Video: Raspberry Pi Pico + NVIDIA Jetson - It's About Time!

Setting up a NVIDIA Jetson to program a Raspberry Pi Pico is straightforward using the installation script shown in the video. Full article on JetsonHacks: https://wp.me/p7ZgI9-3jd

Raspberry Pi Pico on Amazon: https://amzn.to/3qBHl01

The Pico is also available at Adafruit and Sparkfun. If you need a bunch of them, check out Digikey.

Pico starter kit: https://amzn.to/3d4tI6u

00:00 Introduction - About Time

03:25 Raspberry Pi Documentation

04:55 Install Thonny

06:24 Install MicroPython Examples

07:12 Install MicroPython from Thonny

08:05 Demos

11:41 Erase Pico - Reset to Factory Settings

Links mentioned in the video:

Raspberry Pi Documentation:

https://www.raspberrypi.com/documentation/microcontrollers/

Pico and Pico W

https://www.raspberrypi.com/documentation/microcontrollers/raspberry-pi-pico.html

MicroPython on Raspberry Pi Pico Documentation:

https://www.raspberrypi.com/documentation/microcontrollers/micropython.html

Blink an LED is section 2.5 in the MicroPython Documentation book.

MicroPython examples:

https://github.com/raspberrypi/pico-micropython-examples

JetsonHacks installThonny:

https://github.com/jetsonhacks/installThonny

Show Note:

In the video, we use the Thonny IDE to program a Pico H (Pico with Headers) in MicroPython from a Jetson Nano 4GB. The Jetson Nano is running JetPack 4.6 (L4T 32.7.1)

Website: http://jetsonhacks.com

Github: https://github.com/jetsonhacksnano

Twitter: http://twitter.com/jetsonhacks

Some of these links here are affiliate links. As an Amazon Associate I earn from qualifying purchases at no extra cost to you.